Verylube Lithium Grease for CV Joints

არ არის მარაგში

რაოდენობა

არ არის მარაგში

100% Original

Official Georgian Xado Representative

Molybdenum disulphide grease for constant velocity joints (CV joints).

Traditionally used in the joints of equal angular velocities of front-wheel and all-wheel drive cars. Maintains a point contact load of 3500 N.

აღწერა
პროდუქტის დეტალები

Special grease for CV Joints
Reliably protects the nodes and bearings operating at peak and / or alternating loads
It has high mechanical and chemical stability, retains its protective and anti-wear properties even after prolonged mechanical and thermal overloads.
Due to its strong stickiness, it remains on lubricated surfaces even under the action of vibration and high rotational speeds.
It is water repellent and can be used in units operating in contact with water.
Forms good insulation, and prevents bearing contamination

Color, visually: black
Consistency class NLGI: 2
Penetration at +25 ° С, х10-1 mm: 285
Dropping point, ° C: above + 180
Working temperature: long-term, ° C: not higher than 130
Operating temperature: short term, ° C: no higher than 150
The lubricant is compatible with all types of automotive and industrial lithium-based lubricants, mixed with them in any ratio

Specifications and technologies

meets the requirements of specifications:

NLGI 2 (ASTM D217)	ISO-L-XCEB 2 (ISO 6743-9)
KPF2N-25 (DIN 51502)

Detailed specifications

Application

It can be used as a substitute for lithium-based multi-purpose greases in assemblies and bearings of automobiles, industrial equipment. It contains pure highly dispersed molybdenum disulfide, due to which it reliably protects nodes and bearings operating under peak and / or alternating loads.

When using a filling syringe for grease. Lubricate the assembly through the grease fitting until it appears from the gaps of the lubricated compound.

When putting the grease in the hinge of equal angular speeds (CV Joints.) Remove the protective cover, remove the old grease, remove the CV JOINT, disassemble it, having previously marked the relative position of all parts. Wash the parts, assemble the CV joints, observing the relative position of the parts on the marked marks. Completely fill the inner CV joint cavity with grease, install the protective cover and put the CV joint in place.

With a manual tab. To fill with greasing 1/2 of free volume of the bearing (knot), having removed before it old greasing.