XADO Atomic Metal Conditioner Moto 90 ml

60,00 ₾

Tax included

Quantité

Disponible

100% Original

Official Georgian Xado Representative

Atomic metal conditioner MOTO MAXIMUM.

MOTO MAXIMUM atomic metal conditioner is an innovative four-component product of the latest generation, which combines the advantages of a two-phase complex metal conditioner and a REVITALIZANT component of the 3+ generation

Description
Détail du produit

Specially designed for four-stroke motorcycle engines.

Restores metal friction surfaces and compensates for current activation
Aligns and increases compression in cylinders
Increases the pressure in the oil system to nominal
Creates a system of active protection of metal friction surfaces against loads and overheating

Reduces noise and vibration levels
Improves oil lubricating properties and tribological characteristics of engine components
Increases engine power and reception
Reduces fuel consumption

What is a revitalizer?

Application instructions

Warm up the engine to the operating temperature.
Turn off the engine.
Warm up the bottle with the product in any safe way up to +25…+45 °С.
Remove the oil filler plug.
Thoroughly shake the bottle and introduce its contents into the lubrication system. After the introduction, check the oil level: it should not exceed the maximum mark of the dipstick.
If there are any granules left in the bottle, pour some motor oil inside, shake it and then introduce the oil into the lubrication system.
Reinstall the oil filler plug.
Start the engine.
Let the engine idle for 5–8 minutes.
Operate the engine in regular mode without overloads.
The full treatment cycle is completed within 800–1,000 km of run or 20–25 hours of total operation of the engine.

Dosage

One 90 ml bottle is enough for full treatment of the engine with the oil bath volume of up to 1.5 L.

Engines with the oil bath volume of up to 0.5 L are treated with the product in two stages: first, half of the bottle contents is introduced, then, after 4–5 hours of total operation, the rest of the product is introduced into the warmed up engine in the same way.

Notes

It is optimal to conduct treatment after a scheduled change of motor oil or when the engine ran on fresh oil for a short period.

The repeated preventive treatment of the engine is recommended after 16,000–20,000 km of run or 400–500 hours of total operation.

Granules of the composition completely dissolve in the warmed up motor oil within 1–2 minutes.

The product works only in metal-to-metal friction pairs.

Application

The temperature of the product must not be lower than +25 °C before use. Shake the balloon. Apply its contents to the oil filling hole of the engine heated to the operating temperature. Start the engine and ensure its idling operation for 3–5 minutes so that the product mixes evenly with the oil in the oil system. In the future, operate the engine in normal mode.

Note:

The atomic metal conditioner is specially designed for four-stroke motorcycle engines. The product is compatible with all engine oils and can be used in motorcycle and other motorcycle engines with an oil system capacity of up to 2 liters. REVITALIZATION occurs within 20–30 hours (1000–1500 km run); it is not recommended to replace the oil during this period. The particles of the atomic component of REVITALIZANT are completely dissolved in the motor oil heated to the operating temperature.

Dosage:

One 90 ml cylinder is sufficient for an engine with an oil system capacity of up to 2 L. The oil level should not exceed the maximum mark on the probe. Do not overdose!.